Buzz
While changing the IP address for Windows is straightforward, how do you do it for Linux? The guide on changing IP addresses using commands on Linux will outline each specific step for you.
This trick works on all Debian-based Linux distributions, including Ubuntu. To begin, enter the following command in the Terminal window and press Enter:
ifconfig Command
This command lists all network interfaces on the system. Make a note of the network name you want to change the IP address for. Learn how to
To modify settings, use the ifconfig command with additional parameters. The following command changes the IP address of the network interface named eth0 to 192.168.0.1 and assigns a subnet mask of 255.255.255.0:
sudo ifconfig eth0 192.168.0.1 netmask 255.255.255.0
Certainly, you can modify any value as desired. Running the ifconfig command again will apply the new settings to the network interface you modified.
In addition, you can change the Default Gateway that the network interface uses using the route command, alongside changing the IP address via command line on Linux. For example, the following command sets the Default Gateway for the eth0 network to 192.168.0.253:
sudo route add default gw 192.168.0.253 eth0
To view the new settings, you will need to check the routing table. Enter the following command in the Terminal window and press Enter:
route -n Command
Here is how you can change IP addresses using commands on Linux. Additionally, you can explore other methods on the internet to modify IP addresses on Linux. Best of luck with your endeavors!
