Buzz
If your home TV remote is malfunctioning, working intermittently, you can try repairing it yourself with the following instructions.
1. DIY Home TV Remote Repair
If your home TV remote is malfunctioning, working intermittently, you can try repairing it yourself with the following instructions.
Signs of Remote Malfunction
While using it, a button or button area on the remote suddenly loses signal. Or worse, the remote no longer controls the TV. These are indications that your home TV remote has issues.
Common Causes of TV Remote Malfunction
- Battery depletion or damaged battery.
- Excessive and repeated pressing of buttons on the TV remote causing button damage.
- Malfunction of the signal receiver on the TV remote.
- Defective circuitry in the remote.
Identify the Cause of TV Remote Malfunction First
Simple Steps to Repair TV Remote at Home
When encountering issues with the TV remote, it's advisable to first check the battery. If it's depleted or damaged, replace it. Next, clean the signal light on the TV remote. Then, retest the remote; if it's still not working, continue to...
Check the Battery of TV Remote
Essential Tools for Home TV Remote Repair
Step 1: Remove the battery from the TV remote before starting repairs.
Step 2: Use a screwdriver to unscrew the remote, but be careful not to lose the screws. Before completely disassembling the remote, take pictures to accurately document the position of each component to avoid confusion when reassembling.
Step 3: Separate the two pieces of the remote to reveal the rubber piece containing the buttons or individual rubber buttons. Clean the rubber buttons by soaking them in warm water or dishwashing liquid solution. Then, dry them thoroughly in a shaded or well-ventilated area.
Step 4: Use conductive paint to reapply on the inner surface of the rubber buttons (where they come into contact with the remote circuit board). After 24 hours, the paint will dry, but it may take up to 72 hours to see the effect and the remote functioning normally.
Step 5: Gently use a cotton swab to remove dust and dirt from the circuit board of the TV remote.
Step 6: Finally, carefully reassemble the TV remote exactly as it was originally, and perform a final check to see if the remote is functioning. If the answer is no, you should contact electronics repair shops for inspection or consider purchasing a new remote.
