Buzz
From time to time, your Honeywell QuietSet tower fan gathers dust, lint, hair, or other debris, necessitating a thorough cleaning. This process requires a bit of time, patience, and confidence, but it's manageable with moderate skills.
Steps
First, switch off the fan and disconnect it from the power outlet, ensuring it stays unplugged throughout the entire procedure.
For this task, you'll need a Philips screwdriver and an appropriately sized Allen wrench.
Position the unit sideways (preferably on an old towel to prevent scratching) and loosen the 2 thumbscrews located at the bottom of the fan; set them aside. Ensure not to remove the screws securing the rubber feet.
Gently separate the base into two halves by pulling them apart. They easily snap apart and together.
While the fan is still sideways, rotate it so that the back is facing you. Unscrew the 2 bottom side screws using an Allen wrench and keep them aside. Towards the bottom center, unscrew the single screw with an Allen wrench and set it aside. Proceed to remove the 4 screws at the top using a Phillips screwdriver and set them aside as well.
Delicately detach the control panel from the top of the fan. There are 2 internal screws located at the front of the fan that must be removed. Be cautious not to apply too much force, as it may break the tabs securing the control panel to the fan. Once separated at the back, insert a Phillips screwdriver into either side and unscrew the 2 screws holding the control panel in position; set them aside.
Take note of the small, translucent tab situated at the top center on the front. This tab holds the remote control sensor. If it comes loose, set it aside for reassembly later.
Now, the back of the fan should be fully separated from the front. If you encounter difficulty, lift straight up to avoid damaging the screw housings.
There are currently 6 screws securing the internal wind tunnel in place. Be cautious not to tug too hard as it may strain the wiring between the control panel and the motor. Unscrew these 6 screws using a Phillips screwdriver and set them aside. Loosen the set screw on the motor by 3 or 4 complete turns. From the top, lift the cylindrical fan blades away from the motor. Remove the cap from the top of the fan blades and set it aside. With a bit of gentle persuasion, the fan blades should separate easily.
Exercise caution when pulling out the fan blades to avoid putting strain on the wiring between the control panel and the motor.
Separate the wind tunnel from the front housing with care. Remember to lift straight up to prevent cracking or breaking of the screw housings.
Now, you can proceed to clean the entire fan. You can choose from the following methods:
- Utilize a can of compressed air to clean the unit, followed by wiping it down with a soft cloth (preferably done outdoors).
- Vacuum the unit with a soft brush attachment, then wipe it down with a soft cloth.
- Thoroughly wipe down the fan with a soft, damp cloth (especially beneficial for individuals prone to allergies).
When reassembling, ensure that the wiring is routed correctly, the remote control sensor is positioned correctly, and the translucent tab is placed back in its original position.
Charles Platt, Expert Tinkerer and Circuitry Enthusiast
When dismantling any appliance, patience and precision are paramount. Carefully organize each screw and component, making note of wiring connections. Employ compressed air, soft brushes, and isopropyl alcohol to remove debris without causing harm to delicate parts. Reassembly follows the reverse order, ensuring components are firmly seated without over-tightening screws. With mindfulness and the appropriate tools, these quiet machines can be rejuvenated to operate smoothly for many more years.
Helpful Tips
-
To simplify reassembly, arrange the screws in a pattern that mirrors their original positions. Alternatively, place them on a labeled piece of paper to indicate their locations.
Warnings
- Failure to disconnect the fan from power while disassembling or at any point during the process may result in electric shock, discomfort, or even fatal injury.
