Buzz
Guide to Fixing Continuous Blinking Yellow and Red Printer Lights
Here we divide into 2 possible scenarios and through that, you can refer and proceed to fix the issue.
1. Continuous Blinking Yellow and Red Printer Lights Due to Hardware Fault.
Regarding the issue, it is certain that it is due to the toner cartridge, and using reset chip tools to fix it. Of course, with these tools, we need to contact the supplier, those who sell this product line, or the product manufacturer you purchased from for support. Do not attempt to remove or replace chips on each toner cartridge by yourself as it will only make the printer not recognize the toner cartridge.
Also, it's essential to note that when purchasing, it's advisable to buy genuine ink cartridges. Using counterfeit cartridges can easily result in the printer not recognizing the cartridge, recognizing the chip, and can also damage the printer if the cartridge accepts it.
2. Continuous Blinking Yellow and Red Printer Lights Due to Software Issue
The software issue here will be resolved by using software to reset the chip, eliminating the Garena error of continuous blinking yellow and red printer lights. Of course, these tools only apply to Epson printers, so if you're using other brands, contact the warranty provider for the earliest support.
For those using Epson inkjet printers, you can download the SSC Service Utility tool here. This tool allows you to reset the ink cartridge chip for most Epson inkjet printers.
Step 1: Once the software download is complete, click to run and press Yes when prompted for confirmation.
Step 2: On the setup interface, press Next until the installation is complete.
Step 3: After completing the software installation, click Finish to start the software.
Step 4: On the software interface, select the installed printer name and model under Installed Printers and Printer Model respectively in the Configuration section.
Step 5: Then go back to the Ink Monitor tab and click on Refresh.
After that, you can close this program.
Step 6: In the Taskbar, you'll see the SSC Utility icon, click on it, select Protection counter > Reset Protection counter to reset the counter for the chip.
A confirmation prompt will appear asking you to confirm the reset, click Yes.
Upon receiving the notification Waste counter resetted, it indicates a successful reset and the possibility of resolving the continuous blinking yellow and red printer lights issue.
Above are 2 scenarios to help you fix the continuous blinking yellow and red printer lights issue, eliminating the annoyance on color printers, Epson printers. Save time and get back to work faster.
Additionally, for those who use color printers, you're likely concerned about the remaining ink levels. Color printers can fully check this, and you can check the ink levels with our suggestions.
